Scenario 1 ISOmaker problems

Post by **dashelj** » Sun May 17 2015 9:15pm

I am able to create an ISO of my Scenario 1 disk using IMGburn which will run in SSF (latest version). However, when I use the ISOmaker to patch scenario 1 it results in SSF loading to garbled graphics and freezing. Note this is if I use ISOmaker on a mounted ISO or on the actual disc.

Could be any number of problems I guess, but has anyone encountered something like this?

Thanks!

Just getting around to finally playing the scenarios 2 and 3. They have been laying a box for too many years. I appreciate all the hard work of this team.

Post by **legalize freedom** » Wed May 20 2015 6:19pm

Very hard to pin down the cause with the info given.

I would just say stick with using the disc to simplify the operation and follow the instructions on the Patch Instruction page exactly. Note #3 under troubleshooting.

http://sf3trans.shiningforcecentral.com ... tructions/

Post by **dashelj** » Thu May 21 2015 2:48am

It was successful this time! Thank you for your suggestion - I should have read the troubleshooting more thoroughly. Good thing I didnt progress to far in the unpatched version!

Thanks

Post by **legalize freedom** » Thu May 21 2015 11:44am

Good to hear!

If you have played past all the cut scenes at the beginning, you should re-watch those. Many improvements there.

Post by **Hattari** » Fri May 22 2015 12:47am

Is it possible to apply the English patch for the import version of scn1?

Post by **legalize freedom** » Fri May 22 2015 11:46am

No, it is not. The Sc1 patch will only work on the NA or PAL versions (US or UK).

Post by **Hattari** » Fri May 22 2015 10:20pm

Oh well; thanks for confirmation. If only there were a way to play with English text and Japanese voices...it can be hard to go back to the localized VAs after playing the import.

SFIII Translation Project: Scenario 1 ISOmaker problems